A chemical manufacturer issued a PO for a new wastewater treatment system from Dynatec. Our customer is in the process of a major plant expansion and needed to meet new, stricter discharge limits. The wastewater is high in oil and grease, BOD, and COD. The new system will consist of an ultrafiltration system followed by a membrane bioreactor (MBR). The performance of this system was proven over several months of piloting. The results confirmed the selection of UF followed by MBR. The BOD in the permeate was regularly non-detect, down from as high as 40,000ppm in the raw wastewater. All other discharge limits were easily met.
Chemical wastewater treatment utilizing membrane systems that range from selective separation of product to wastewater treatment and reuse. Dynatec Systems has provided many different chemical wastewater solutions.
- Ultrafiltration (UF), Nanofiltration (NF) and Reverse Osmosis (RO) for selective separation of product for recovery
- MBR biological treatment
- Wastewater reuse with MBR
- Conversions of existing systems to MBR
- Expand existing bioreactor treatment capacity
- Improve discharge quality
- Produce water for reuse
- Reduce surcharge
- High purity reuse with MBR and RO
Contaminants Removed
- Organics
- Inorganic solids
- Phenol
- Solvents
- Oils
- Acids
Ultrafiltration offers the following advantages over conventional separation:
- No chemical required
- Very little labor required
- Simple mechanical process
- Less sludge
- Ability to concentrate the retentate for beneficial use
- Less space required
- Overall lower operating costs
Dynatec specializes in extensive RO and NF membrane systems to remove soluble components of wastewater that may not have been removed by primary treatment. In most cases, the purified water can be reused.
RO is capable of rejecting soluble constituents of aqueous streams, such as:
- Bacteria
- Salts
- Sugars
- Proteins
- A wide range of organics and colors
- Improves the color, taste and properties of the fluid
RO can be used to purify fluids such as ethanol, which will pass through the reverse osmosis membrane, while rejecting other ions and contaminants from passing.
RO/NF systems
The most common use for reverse osmosis is in purifying water. It is used to produce water that meets the most demanding specifications. This differs significantly from other RO systems that are often only designed to treat potable water. Our system is specifically designed to accommodate:
- Minimize reject volume
- Variable characteristics
- Minimize fouling
RO and NF Technology
RO uses a membrane that is semi-permeable, allowing the fluid that is being purified to pass through it, while rejecting the contaminants that remain. Most NF and RO systems are operated in crossflow to allow the membrane to continually clean itself.
Integrated clean-in-place (CIP)
The membrane skid has an integrated CIP system on the skid. This is especially important for wastewater reuse systems because the cleaning frequency of the skid is often higher than in other RO applications. With an integrated CIP system, cleaning is fast and easy, minimizing the operator’s time.
Tubular Configuration:
- Higher permeate rate
- Lower rates of fouling
- Higher concentration of retentate
- Easier to clean
- Longer membrane life
- Low operating cost
To discuss your wastewater treatment solution, please contact us today.